Before starting to grow your own medical cannabis, you should read some important information about the process of germination. Basically, the process involves soaking the seeds in distilled water or stone wool blocks. You can also try jiffy pellets. However, be sure to avoid exposing the seeds to direct sunlight. The right moisture balance is the key to germinating medical cannabis seeds successfully.
Soak Medical Cannabis Seeds in Distilled Water
The first step in germinating your medical cannabis seeds is to soak them. The same process is followed as with any soil-based growing medium. The benefits of soaking cannabis seeds in stone wool blocks are that they retain moisture and do not need to be watered at all, especially during the early stages of germination. Once the stones have been soaked and dried, place them in a plastic tray or tub with a lid. Large cake tubs work well for this task.
Soaking cannabis seeds in distilled water is a simple and effective way to get ready to plant your flowering kush. Make sure you soak them overnight. To do this, fill a glass cup with about three-quarters of water. It should be pH neutral and lukewarm. Also, you should soak them for several days if you intend to grow a large plant.
Soak Medical Cannabis Seeds In Jiffy Pellets
Once you have soaked your marijuana seeds, you can transplant them into a pot or direct-seed your plants in the soil. Seedlings will develop a root zone and spread through the jiffy pellet. They will begin to develop “true leaves” – these are larger than suckers and look more like typical cannabis leaves. This is a sign of future growth and establishment.
Avoid putting cannabis seeds in direct sunlight
Some horticulturists recommend sterilizing the soil before planting cannabis seeds into it to germinate. Sterilizing the soil can be achieved by placing it in a convection oven at 200F for 30 minutes or by using a microwave on high for two minutes. You can also do this step outside in the sun for ten days. Water the soil, then make a small hole with a pencil eraser and plant the seed. After about a week, it should sprout its first tail.
Read Also: Cannabis Oil: 5 Health Benefits of CBD Oil
Orient medical cannabis seeds
Orient cannabis seeds are similar to most marijuana seeds in that they are slightly oval in shape. At one end, they have a point, and at the other, they form a crater. These two ends are called the crown, and the crown should be facing upwards when you plant them. Imbibing water is the most important thing to remember when you germinate cannabis seeds. If you do not, the plant will grow runty and will never reach the light.
Check the pH of the water
Before germinating your cannabis seeds, you should check the pH of the water. Cannabis prefers a pH range of 5.8 to 6.2, but higher values may result in Fe deficiency and interveinal chlorosis in the upper leaves. Attempting to lower the pH of your substrate can be challenging and may not result in the desired outcome. However, using an acidic-based fertilizer will moderate the pH of your water over time.
Prepare soil
In preparation for the seedlings, you need to test the soil for its specific characteristics. For example, the soil should be between six and seven pH, have the right amount of water retention, and allow air to pass through. Some soils are so compacted that they are not conducive to growing cannabis. The best location for the cultivation of cannabis seeds is a sunny, flat area, with lots of privacy.
Read Also: How to Vape Cannabis Flowers: A Guide
Transplant cannabis seeds
Transplanting cannabis seeds is easy, but there are some tips you should remember. First of all, make sure that you don’t transplant too soon – this will seriously damage your plant’s rootstock. Second, always prepare your new growing medium properly to avoid soil nutrient imbalances and pests. Lastly, make sure to recycle your old earth to maintain pH levels. It also helps to loosen the soil and increase oxygen levels.
Stay tuned to enviro360 for more infotainment news.